AFTER USE
1) Turn the intensity control OFF
Turn the intensity control in anticlockwise to
OFF.
2) Disconnect wire and electrode
Pull out the wire from the output jack. Leave
the electrode on the skin if another treatment
is going to start with severel minutes. After a
treatment session is finished, take off the
electrode and clean your skin.
26
25
7) Battery power indicator :
full-scale battery, power full
half-scale battery, power low
8) Adjust channel amplitude :
Turn channel 1 or 2 clockwise. The indicator
will light up as long as the unit is in stimulation.
Slowly turn the channel control in a clockwise
direction until you reach the setting
recommended by your clinician. Repeat for the
other channel, if both channels are to be used.
Indicator light will blink at lower pulse rate
setting or keep solid when the pulse rate
setting is high. The display will show the output
current in mA when the channel amplitude is
adjusted.
Note : the number / function reads on the
display will be the last number / function
adjusted.
9) Time memory control :
Read total treatment time : Press the
MODE
+
key to read total treatment time.
Reset the timer recording to zero : Press the
MODE
+ key to reset the timer record.
10) Parameters reset control : Press and hold
the Mode key before you turn on the unit.
