Graef ES 85, Инструкция по эксплуатации

Страница: 5 / 8

5
EN
hot water nozzle.
∙
Open the control dial.
Programming
This unit comes with the following fac-
tory settings:
Single espresso – 30 ml
Double espresso – 60 ml
In the following section you can also
change them and set them however
you like:
Programming “Single Espresso”
∙
Turn the unit off.
∙
Press and hold button, then
press and release button
∙
Relase button.
∙
After realisng button, brewing
will be started automatically. When
desired coffe volume is achieved, then
press
button again to stop brew-
ing.
Programming “Double Espresso”
∙
Turn the unit off.
∙
Press and hold button, then
press and release button.
∙
Release button.
∙
After releasing button, brewing
will be started automatically. When
desired coffee volume is achieved,
press 2 cups button again to stop
brewing and saving setting.
Programming “Temperature”
Make sure the unit is turned off!
Espresso temperature
∙
Press and hold MANUAL button, then
press and release
button.
∙
Release MANUAL button.
∙
Press button for decreasing the
temperatur. Press button for in-
creasing the temperature. 3 positiv and
3 negative levels can be set.
∙
Press MANUAL button for 3 seconds
to save and leave the program setting.
Steam
∙
Press and hold & buttons,
then press and release button.
∙
Release & buttons.
∙
Press button for decreasing the
flow rate. Press button for incre-
asing the flow rate. 3 positive and 3
negative levels can be set
∙
Press steam button for 3 seconds to
save and leave the program setting.
Factory setting:
Press button for 3 seconds.
Decalcification
∙
Please fill approx. 1.5 l of water into
the water tank.
∙
Put a decalcification tab e.g. the Graef
decalcification tab, art.-no. 145618,
into the water tank and wait for ap-
prox. 5 minutes for the tab to dissolve.
∙
Place a big cup under the group hand-
le.
∙
Press button and wait for a few
seconds.
∙
Press the “MANUAL” button.
∙
When the cup is completely filled,
press the “MANUAL” button again to
stop the extraction.
∙
Repeat this step approx. 4 times.
∙
Please wait for another 15 minutes and
repeat the abovementioned step until
the water tank is empty.
∙
Refill the water tank and extract water
5 times.
∙
Now, you can proceed to prepare your
espresso as normal.
Decalcification of the milk froth /
hot water jet
∙
Please fill approx. 1 l of water into the
water tank.
∙
Put a decalcification tab e.g. the Graef
decalcification tab, art.-no. 145618,
into the water tank and wait for ap-
prox. 5 minutes for the tab to dissolve.
∙
Place a big cup under the milk froth /
hot water jet.
∙
Remove the pannarello and unscrew
the jet.
∙
You can put the jet into the cup.
∙
Make sure the unit is turned off.
∙
Press and hold the “MANUAL” and
”button for 3 seconds. Then,
press and directly release the
button.
∙
Now, please release the “MANUAL”
and
button.
∙
The water temperature gets reduced.
∙
Please open the control dial.
∙
Discontinue this step several times, so
that the pump does not get strained
too much.
Cleaning
∙
Clean the exterior of the unit with a
soft, moist cloth. If heavily soiled, a
mild detergent can be used.
∙
Pull out the drip dish.
∙
Remove the drip grate.
∙
Empty the drip dish.
∙
Clean the drip tray and the grate and
the group handle under running water.
∙
Then replace the drip dish together
with the grate.
Cleaningfunction
∙
Remove the water tank and dispose of
the old water.
∙
Fill with approx. 1 Liter fresh, cold wa-
ter.
∙
Put the filter insert for 2 cups into the
group handle.
∙
Place the cleaning disk (with the
smooth side facing down) into the fil-
ter insert.
∙
Also put a cleaning tab e.g. Graef
cleaning tab article no 145614 into the
filter insert.
∙
Now insert the group handle.
∙
Put a large container underneath the
group handle.
∙
Make sure the unit is switched off.
∙
Press and hold and but-
tons for 3 seconds, then press and re-
lease
button.
∙
Release & buttons
∙
Cleaning procedure will be started au-
tomatically.
∙
After a while you will hear 4 beeps, it
means cleaning is done.
∙
Remove the cleaning disc.
∙
Take out the filter insert and clean it
with warm, soapy water.
∙
Your unit is now ready for use again.