
8-9
Chapter 8: Freedom 325
Freshwater Washdown
To operate the freshwater washdown system, place the freshwater switch on the helm switch
panel in the “on” position. This system will now be pressurized at the freshwater outlets. A hose
with a spray nozzle attached may be used intermittently without turning the switch off in the same
fashion as a garden hose with a nozzle. The freshwater pump has an internal pressurization switch
that will maintain water pressure as needed until the switch is turned off.
Generator
The generator enables you to use AC accessories without being attached to shore power. A
Fischer Panda™ model 5000, capable of producing 5000 peak watts (41.7A) and a constant
4500 watts (37.5A) is installed on your boat. A separate 12 gallon (45 L) diesel tank located in the
aft rigging area supplies fuel to the diesel generator. The diesel fuel level may be monitored using
the gauge located near the generator control panel.
Generator Control Panel
The generator control panel is located below the AC/DC panel. To learn more about how to
operate this panel, reference the Fischer Panda owner’s manual included in your Owner’s Packet.
Amperage Requirements
The generator provides sufficient power to operate most accessories at the same time. A list of
amperage requirements for all AC accessories is provided below. Use the amp meters and volt meter
on the AC panel to properly manage the load on the generator. The generator is capable of handling
momentary peaks above its rated capacity. These peaks are normally related to the start-up of each
accessory. In addition to the factory installed appliances, you should know the amperage
requirements of any household objects you bring on board.
•
Water Heater
12.5A
(6.3) 50Hz
Maximum Amps
•
Air Conditioner
11.0A
(4.5) 50Hz
Running Amps
•
Grill
10.8A
(5.4) 50 Hz
Maximum Amps
•
Battery Charger
8.0A
(4) 50Hz
Maximum Amps
C A U T I O N
Do not leave the generator seacock open while the boat is in motion and the generator is off.
You can use the generator while the boat is moving. However, when the generator is shut down
the intake seacock should be closed immediately. If the seacock remains open, excessive
seawater may be forced into the generator cooling system causing water to back up into the
exhaust manifold.
AC Transfer Switch
The AC transfer switch is located on the generator control panel. This switch permits you to
operate your AC accessories by either shore power or generator. This switch prevents the operation
of the shore power and the generator simultaneously.
Содержание Freedom 325
