M
A I N T E N A N C E A N D
S
E R V I C E
6–5
Storage
Consider the following steps when putting your folding top canvas option in the stored
position:
•Fold the top and zip it into the canvas cover provided.
•Pivot the covered top into the stowed position on the foredeck. The canvas cover is
equipped with a strap on each side and an eyelet in each strap. Place the eyelets over the
male fasteners located on the port and starboard foredeck.
•Twist the male fastener 90 degrees to engage.
H
ARDWARE
M
OUNTING
Ensure all holes are sealed properly when for mounting hardware in boat surfaces. Sealing
will prevent water leakage. That is extremely important in fiberglass areas that have been
reinforced with plywood. A drilled hole sealed improperly allows water inside the fiberglass
allowing the plywood reinforcement to become saturated.
C
AULKING
/G
ASKET
Deck fittings, bow rails, windows, hatches, etc. have been caulked or gasketed with the
highest quality material to ensure a waterproof joint with the boat. However, the working action
of normal use will tend to flex the joint and eventually break down the seal. Periodically inspect
the caulking or gaskets for leaks. Recaulk or replace the gaskets when necessary, or have your
dealer do the repairs.
S
TAINLESS
S
TEEL
R
AILS
& H
ARDWARE
Your hardware is made of laboratory grade 316 stainless steel and needs regular cleaning to
maintain its “less staining” properties. The key to maintaining stainless steel is to keep it clean
using a mild solution of soap and fresh water. Remove salt or dirt from your stainless steel on a
regular basis.
S
CUPPERS
Grady-White boats have self-bailing cockpits. This means water on the cockpit floor drains by
gravity through large aft scuppers and
NOT
into the bilge. The aft drains or scuppers have an
external flap assembly which restricts the flow of water back into the boat. Inspect the flaps
periodically to make sure that they are free of debris. The scupper flaps may need replacement if
the rubber becomes damaged or no longer seals properly in the thru-hull.
S
HOWER
S
UMP
A shower in the head compartment drains into a contained “sump” which is used to prevent
hair, soap, scum and bacteria from accumulating in the bilge and creating odors. This sump
should be cleaned regularly. The sump pump box contains a filter. Remove the filter and rinse
with water to clean. The filter should always be installed when using the shower to prevent the
sump pump from becoming clogged.
C A U T I O N
Secure the folded top when in the stowed position to prevent damage or the loss of the canvas.
!