Gradall LOED 534A, Руководство по обслуживанию

Страница: 63 / 91

Examine the isolation plates. You
will note that they are slightly
different. Choose the two having
rounded edges as shown. Install
these two (11) in the bottom of
the motor body with the rounded
edges down and in their proper
location. (No isolation plates
in SPM25.) (Fig. 94)
Install pressure plate (9) (13, in
SPM25) with the bronze side up.
Keep the plate as level as possible
and slide it down to the bottom of
the body. DO NOT FORCE THE PLATE.
Coat the journals of drive gear (6)
with clean hydraulic oil and with the
splined end up, insert it into the
bore nearest you. DO NOT DROP IT
INTO PLACE. Slide it into place
gently. Dropping it will damage
the bronze face of the pressure
plate. (Fig. 95)
Coat the idler gear (8) journals
with clean hydraulic oil and install
it in the opposite bore. (Fig. 96)
Before continuing to assemble the
motor, it will be necessary at this
point to position the drive gear in
this section for proper timing as
shown in Sketch ‘A’.
Install top pressure plate (9) (12,
in SPM25) with the bronze side down.
31.
32.
33.
63
34.
35.
36.
FIGURE 94
FIGURE 95
FIGURE 96