SHUTDOWN, CLEANUP AND FASTFLUSH
GRACO DISTRIBUTION BVBA
Industrieterrein Oude Bunders
Slakweidestraat 31 • B-3630 Maasmechelen
Tel: +32 (89) 770 700 • Fax: +32 (89) 770 777
www.graco.com
© 2016 Graco Distribution BVBA · Form No. 328006ENEU (rev E)· 07/17 · Digital version only.
Graco is certified ISO 9001.
SPRAYING
All information, illustrations, and specifications in this document are based on the latest product information
available at the time of publication. The right is reserved to make changes at any time without notice.
Point gun at area to be sprayed about 30 cm from surface, and begin moving gun before triggering.
A good spray pattern is evenly distributed as it hits surface. Set pressure just high enough to spray without
heavy edges. Use smaller tip size for thinner material and a larger tip size for thicker material if pressure
adjustment cannot achieve even spray pattern.
Trigger gun
until pressure
is relieved.
Turn prime valve down
to DRAIN position
and then over
to FAST FLUSH
Trigger gun into waste pail
Keep gun triggered and
turn pressure knob
to use FAST FLUSH
until water coming
out of gun is clean.
Wipe outside of sprayer, hose
and gun with rag soaked
in water or mineral spirits.
Turn prime valve
to Prime position
(down).
Turn prime valve down to stop
FAST FLUSH, keep the pump running til
clear water comes out the drain tube.
Turn pressure
control knob to lowest setting.
Remove filters from gun and sprayer, if
installed.
Clean and inspect filter, assemble gun
and filter house, without filter.
Check inlet strainer for
clogs and debris
Increase pressure
until sprayer starts.
As soon as Pump Armor
comes out of drain tube,
set power switch to OFF.
Set power
switch to OFF.
Turn safety lever of gun to OFF.
Turn pressure control knob
to lowest setting,
set power switch to ON
Place drain tube in waste pail
Place drain tube in waste
pail and siphon tube in
container of
Pump Armor™
Place suction tube in appropriate
cleaning fluid
Remove tip guard
Screw inlet screen onto
siphon tube, replace
manifold filter and spacer,
and assemble gun with
filter, tip and guard.
WASTE
WASTE
Fill throat packing nut
with TSL™
