Graco TrueCoat 360 17D889, Руководство пользователя

Страница: 18 / 32

Common Procedures
18 333394H
Common Procedures
Installing Spray Tips
Two spray tips are available for use with this
sprayer. The black tip produces a 12-inch
wide spray pattern. The gray tip produces a
4-inch wide spray pattern.
Either spray tip may be used to spray mate-
rials that are recommended to be sprayed
with a 0.015 tip size. See material container
for spray tip size recommendations.
Remove Spray Tip
1. Perform Pressure Relief Procedure ,
page 14 .
2. Rotate the spray tip 90 degrees from
either the SPRAY or UNCLOG position.
3. Pull the spray tip straight out of the spray
tip guard.
Install Spray Tip
1. While holding the spray tip 90 degrees
from either the SPRAY or UNCLOG
position, align spray tip locking tab with
the locking tab slot in the spray tip guard.
2. Push the spray tip all the way into the
spray tip guard.
3. Rotate the spray tip to the SPRAY
position.
NOTE: Make certain spray tip locking tab is
pushed all the way into the slot in the spray tip
guard. You should not be able to remove the
spray tip from the spray tip guard when it is in
the Spray or Unclog positions.
NOTE: If the locking tab slot in the spray tip
guard is blocked, preventing installation of
the spray tip, rotate the spray tip guard until it
is visually aligned with the internal hole, then
install the spray tip.
•
Spray tips wear with use and abrasive
paint and need periodic replacement.
•
If the spray pattern is poor, you may have
a worn spray tip. Replace spray tip. See
Spray Pattern Diagnostics , page 28.
Do not put your hand in front of the spray tip.
ti23563a
LOCKING TAB SLOT
LOCKING
REMOVE
SPRAY TIP
TAB
ROTATE
SPRAY TIP 90
o
NOTICE
The spray tip guard is permanently
attached to the sprayer. Removal for
cleaning is not necessary and will result in
damage to the sprayer.
NOTICE
Spray tips must be cleaned or stored in
appropriate cleaning fluid (water or mineral
spirits) immediately after use to ensure
material is not allowed to dry in spray tip.
Failure to do so will result in damage to the
spray tip. See Cleanup , page 14.