Graco Tradeworks 150, Руководство по эксплуатации

Страница: 7 / 36

Warnings
313381L 7
QUICK START-UP GUIDE
PRIMING
1
Submerge suction tube in paint. Turn power
switch ON, and trigger gun into waste pail. When
paint comes out of drain tube, turn Prime/Spray
valve to SPRAY.
2
When paint comes out of gun, release trigger.
Pump will build up pressure, and motor will
stop.
3
Transfer drain tube to paint pail.
SPRAYING
1
Put trigger safety lever in SAFETY ON position.
2
Install tip and guard on gun, and hand tighten.
Your are now ready to spray.
3
If tip clog occurs, this spray tip reverses,
enabling you to quickly clear obstructions
without disassembly.
4
Turn Pressure Control Knob right (clockwise) to
increase pressure at the gun, and turn it left
(counterclockwise) to decrease the pressure.
5
Point Gun at surface to be sprayed about 12 in. (304 mm) away from surface, and begin
moving the gun before you trigger it. A good spray pattern is evenly distributed as it hits the
surface. Set the pressure so it is just high enough to spray without “tails”. If tails persist at
the highest pressure, a smaller tip is needed to spray the material or material may need to
be thinned.
Project Painter
150/170
WASTE WASTE
PAINT
BAD PATTERN
GOOD PATTERN