Graco ToughTek F680e, Инструкция по эксплуатации

Страница: 28 / 54

Repair
Partial Partial Partial Pump Pump Pump Lower Lower Lower Disassembly Disassembly Disassembly
Perform the procedure below to clean or replace a
portion of the pump lower without removing the entire
pump lower from the unit. Before following the partial
pump lower disassembly procedure, perform the
Pressure Relief Procedure, page 24 and disconnect
the material hose.
1. Loosen the hopper elbow clamps (V), retract the
spring loaded locking pin (Z), and slowly swing
the pump up until the spring loaded locking pin
clicks into place.
2. Remove the hopper elbow (26) from the pump
lower.
3. Remove the inlet housing by unthreading the
extension nuts (831, 832) on the bottom pump
clamps (803).
4. Remove the pump cylinder by unthreading the
extension nuts (831, 832) on the top pump
clamps (803) and sliding the cylinder (804) off
the piston rod packing cup.
28 3A3110K