Graco ti11608a, Руководство по ремонту

Страница: 27 / 30

Motor Replacement
310824D 27
Motor Replacement
See Wiring Diagram, page 28.
Removal
1. Relieve pressure , page 8. Disconnect power cord
from outlet.
2. Remove pump (9). Displacement Pump Replace-
ment , page 14.
3. Remove drive housing, Drive Housing Replace-
ment , page 16.
4. Remove Pressure (Fluid) Manifold, Manifold
Replacement , page 24.
5. Disconnect all leads from board (33) and remove
control board.
Control Board Replacement , page
20.
6. Remove ground wire (G) from motor endbell.
7. Remove four screws (6) and motor (1) from frame
(45).
Installation
1. Install new motor (1) on frame (45) with four screws
(6).
2. Install manifold (15) with two screws (6). Manifold
Replacement , page 24
3. Install control board (33) with three screws (30).
Connect all leads to board. See
Control Board
Replacement , page 20 and Wiring Diagram , page
28.
4. Connect ground wire (G) to motor with green ground
screw (31).
5. Install Drive Housing. Drive Housing Replace-
ment , page 16.
6. Install pump (9). Displacement Pump Replace-
ment , page 14.
7. Install shroud (29) with two screws (30).
WARNING
Read Electric Shock Warning , page 3 and Pressure
Relief Procedure , page 8.
CAUTION
Do not drop gear cluster (3) and (2) when removing
drive housing (5). Gear cluster may stay engaged in
motor frontend bell or drive housing.
6
1
Liberally a pp ly grease
1
1
45
3
2
30
34
31
33
30
1
15
6
ti5642a