Graco Therm-O-Flow 200, Инструкция-перечень запасных частей, Страница: 45 / 109

Repair
Repair Repair Repair
Replace Replace
Replace Wipers
Wipers
Wipers
1. To replace a worn or damaged wiper (V) raise
the ram plate up out of the drum. Perform steps
1 through 7 of
Change Drums, page 36 . See
wiper kit manual for instructions about replacing
the wipers.
Figure 25 Replace Wiper
Replace Replace Replace Platen Platen Platen RTD RTD RTD
Reference Electrical Schematics, page 58 for wiring
connections.
1. If the material drum has already been removed
from the supply unit, go to step 2. If you
need to remove the material drum, see
Change Drums, page 36 .
2. Make sure the ram plate is down and the ram
hand valve is in the OFF position.
To reduce the risk of injury or damage to
equipment, make sure the main power switch
is off before continuing with this procedure.
3. Turn the main power switch off.
4. Remove the pump cover.
Figure 26 Pump Covers and Platen RTD
5. Remove the platen RTD (605) from the platen.
334130D 45