Graco SoloTech ST10, Руководство по ремонту и запасным частям

Страница: 10 / 36

Repair
Repair Repair Repair
Pressure Pressure
Pressure Relief
Relief
Relief Procedure
Procedure
Procedure
Follow the Pressure Relief
Procedure whenever you see this
symbol.
This equipment stays pressurized until pressure
is relieved manually. To help prevent serious
injury from pressurized fluid, such as splashing
in the eyes or on skin, follow the Pressure Relief
Procedure when you stop pumping and before you
clean, check, or service the equipment.
1. Remove power from the system.
2. Open the dispensing valve, if used.
3. Open the fluid drain valve to relieve fluid
pressure. Have a container ready to catch the
drainage.
Before Before Before You You You Start Start Start
1. Flush the pump.
2. Follow the Pressure Relief Procedure, page 10 .
3. Disconnect power to the pump.
4. Make sure the pump is electrically isolated.
Unexpected operation of the pump can cause
serious injury. Remove the fan cover only after
the motor has been locked out.
Drain Drain
Drain the
the
the Lubricant
Lubricant
Lubricant
1. Hold a pail under the drain plug (29) and unscrew
the plug to drain the lubricant. Dispose of the
lubricant properly. Take care, as the lubricant
may be contaminated by the pumped fluid.
2. Remove the vent plug (30) and flush the pump
housing with a compatible solvent.
Figure 1 Pump Drain (29) and Vent (30)
Remove Remove
Remove the
the
the Front
Front
Front Cover
Cover
Cover
1. Drain the lubricant per the instructions in the
previous section.
2. See Figure 2, page 10. Use a wrench to remove
the bolts (45) and washers (52, 53, if present)
that hold the front cover (16), removing the
top screw and washer (if present) last. Take
the cover off the pump. If the cover is stuck,
gently break the gasket seal with a flat-headed
screwdriver between the cover and the housing.
Pump Model Wrench size
ST6 , ST10 , ST23 , and
ST25FG
10 mm
ST26 13 mm
ST30 and ST32 17 mm
3. Remove the front cover gasket (15).
10 3A3367K