2-QUART PRESSURE CUP
3
311417C
OPERATION
1.
Pull out regulator knob and turn fully counter-clockwise. Open
release valve on cup lid (counter-clockwise).
2.
Open lid and fill cup with desired sprayable material.
3.
Close lid and seal by turning clockwise hand-tight.
4.
Close release valve on cup lid hand-tight turning clockwise.
5.
Set wall-mounted regulator (not supplied) to desired PSI (this
is your atomizing air).
6.
Slowly turn the cup regulator knob clockwise while pulling the
gun trigger fully back to commence material flow. Continue
clockwise until desired material flow is achieved. Push in reg-
ulator knob to lock.
Maximum cup pressure is 50 PSI.
7.
To decrease paint flow, pull out regulator knob and turn coun-
ter-clockwise to lower cup pressure. Open the release valve to
bleed off excess pressure. Reseal release valve. Repeat step
6. The cup lid has a check valve that prevents the cup from
losing pressure until the release valve is opened.
8.
Atomizing air for the spray gun can be adjusted at the gun by
means of an air adjusting valve on the spray gun.
Note: To achieve desired cup pressure you must always start at a
lower pressure and adjust up to the desired setting.
MAINTENANCE
Cleaning your cup.
1.
After relieving cup pressure and turning cup pressure regulator to the full “off” position (counter-clockwise), open cup
lid by turning counter-clockwise.
2.
Pour out any remaining material and add a compatible solvent.
3.
section above and spray until clean solvent appears. Cup and gun material
passages should be clean now.
4.
Depressurize cup (
step 1) and empty remaining solvent from cup and wipe clean with a solvent soaked
cloth.
NOTICE
Never clean your Model 7004 in a gun washer. The
safety valve, regulator body and gauge will be dam-
aged by use in a gun washer. The canister only can be
cleaned in a gun washer.
•
Paint can erupt from the cup due to rapid depressurization. Never open the cup prior to turning cup pressure
regulator knob to the full “off” position (counter-clockwise) and relieving cup pressure by opening (counter-
clockwise) release valve.
Cup Pressure
Regulator
Knob
Pressure
Release
Valve
Fluid Outlet
Cup Air Outlet
Pressure
Relief Valve
TI7063
