Graco SD 10 Series, Руководство пользователя

Страница: 19 / 54

Installation
3A8626A 19
4. While wearing heavy gloves, firmly grasp the
outside edge of the reel flange with both hands.
Wind the spool the correct number of turns (see
reference table from Step 1), rotating the reel in the
direction shown in F
IG
. 15.
• Stop only at latching locations.
• Stop the reel where there is access to the hose
swivel (A) (F
IG
. 16), and where the reel is securely
latched.
5. Before installation of the hose, attach a C-clamp (D,
F
IG
. 15) to the reel flange to prevent the reel from
unintentionally becoming unlatched and spinning
freely.
6. Uncoil and extend the hose.
7. Install the hose stop (C) (F
IG
. 16) to the end of the
hose. If the hose has a warning tag (F), the hose
stop should be installed on the same end of the
hose as the warning tag.
NOTE: If the hose is equipped with a spring guard, this
end must be on the same end as the hose stop.
8. Run the end of the hose (B) through the hose guide
(G) and then to the hole (E) in the reel (F
IG
. 16).
9. Attach the hose end (B) to the hose reel swivel (A).
10. Carefully remove the C-clamp (D) (F
IG
. 15),
11. Pull on the hose hard enough to release the latch,
and slowly allow the hose to retract.
12. Re-position the hose stop so the hose extends far
enough for all operators to reach the dispense
valve.
13. Flush the hose following the Flush the Equipment
instructions, page 9.
F
IG
. 15
D
F
IG
. 16
A
B
F
C
G
E