Before You Start
4
3A1292C
Setup Instructions
1.
Perform
Pressure Relief Procedure
(see sprayer
manual).
2.
Remove sprayer battery or unplug sprayer.
3.
Remove material cup (M) and suction tube (T).
4.
Align hose set adapter (A) with sprayer inlet (B) and
insert into sprayer. Thread hose set adapter ring
until tight.
5.
Place liner (optional) into reservoir and fill with
material.
6.
Install suction tube and strainer to inside of lid (be
sure to align center of strainer with center of reser-
voir lid). Install reservoir lid to reservoir and hand
tighten.
7.
Thread suction hose nut (S) onto lid assembly and
hand tighten. Insert drain hose (H) onto lid assembly
barb and secure with clamp.
8.
Install sprayer battery or plug sprayer into a properly
grounded outlet.
9.
Place reservoir on floor, install and turn on air com-
pressor (P). Hold sprayer at approximately chest
level and prime sprayer until material just begins to
fill the drain hose (approximately 1 ft).
ti15504a
M
T
ti16514a
A
B
ti16506a
ti16515a
S
H
ti16509a
1 ft
Drain
Suction
Hose
Hose
ti16504a
P
