Failure to follow these warnings and the
instructions could result in serious injury or death.
Setting Up the
Playard
• THIS PRODUCT REQUIRES ADULT ASSEMBLY.
• Keep fingers clear of top corners during setup. Be sure playard
is completely set up before use. Check that the four top rails are
completely latched, the center of the floor is pushed down, the
mattress/pad is flat, the straps are securely fastened to the bottom of
the unit and the four corners are tucked under the stiffeners. Always
follow the instructions in the owner’s manual to set up the playard.
Using the Playard
• The playard is for playing or sleeping. When used for playing, never
leave child unattended and always keep child in view. When used for
sleeping, you must still provide the supervision necessary for the
continued safety of your child.
• Always keep the playard away from hazards in the area that may
injure your child.
• When child is able to pull to standing position, remove large toys
and other objects that could serve as steps for climbing out.
• Stop using this product when your child reaches 35 inches (89 cm) in
height, weighs more than 30 pounds (14 kg), or is able to climb out.
• Do not modify playard or add any attachments that are not
listed in the owner’s manual, including an add-on bassinet.
• Child can become entrapped and die when improvised netting or
covers are placed on top of a playard. Never add such items to
confine child in playard.
• NEVER leave child in product with side lowered. Be sure side is in
raised and locked position whenever child is in product.
• If refinishing, use a nontoxic finish specified for children’s products.
Содержание Pack n Play Series
