Cleanup
18
3A3240C
Cleanup with Power Flush
Adapter
(Water-based materials only)
Power flushing is a faster method of cleanup.
It can only be used after spraying
water-based coatings.
1.
2.
Remove spray tip and tip guard assem-
bly from gun and place in waste pail.
3.
Place empty waste and paint pails side
by side.
4.
Lift suction tube and drain tube from
paint pail. Let paint drain into the pail.
5.
Place suction and drain tube in waste
pail.
6.
Turn pressure control knob to the
Prime/Clean setting.
7.
Screw Power Flush attachment valve to
garden hose. Close valve.
8.
Turn on water. Open valve. Rinse paint
off suction tube, drain tube and inlet
strainer. Close valve.
9.
Unscrew inlet strainer from suction
tube. Place inlet strainer in waste pail.
10. Connect garden hose to suction tube
with Power Flush attachment valve.
Leave drain tube in waste pail.
11. Turn ON/OFF switch to
ON
position.
12. Open Power Flush attachment valve.
13. Circulate water through sprayer, into
waste pail, for 20 seconds.
14. Turn ON/OFF switch to
OFF
position.
NOTE:
Step 15 is for returning paint in hose
to paint pail. One 50 ft (15 m) hose holds
approximately 1 quart (1 liter) of paint.
15. To recover paint in hose, point gun into
paint pail while holding gun firmly to the
pail.
a.
Disengage trigger lock.
b.
Pull and hold gun trigger.
ti27152a
ti27154a
ti27135a
7155a
ti27
ti27158a
