Graco LubeMaster, Инструкция по эксплуатации

Страница: 7 / 44

Component Identification
3A2781A 7
Component Identification
All LubeMaster Pump Packages include the following
components:
• A reservoir (11) for holding the lubricant.
• A standard pump (101).
Reservoirs (11) - Oil or Grease
• Container for holding oil or grease.
• Grease models include a follower plate.
• The reservoir mounts directly to LubeMaster pump.
Oil Reservoirs
• Reservoirs for oil models have a fill cap (30) and
screen (31), located on top (F
IG
. 2).
Grease Reservoirs
• Grease reservoirs require an external air-free sup-
ply source connected to the fill stud (13).
Pump (101)
• The pump can be driven by an electric motor or by a
rotating or oscillating machine motion.
• The pump must always be installed with the reser-
voir (11) in a vertical position to ensure proper oper-
ation.
• Always use lockwashers with mounting bolts and
make certain that the bolts are properly torqued.
Motors and Drives
Gear Reducer
Gear reducers have either a 10:1 or 60:1 reduction or an
oscillating clutch drive that can be activated by a
machine motion.
• A shaft guard is included if the pump is configured
with a gear reducer.
• The user must provide a guard for any other config-
uration.
Low-Level Switch
Low-level switches protect the system against excessive
pressure and low lubricant levels. The switch provides
an electrical signal when the lubricant level in the reser-
voir is low.
F
IG
. 2
F
IG
. 3
31
30
13
NOTICE
Gear reducer units are shipped without lubricant.
Before operating, always check lubricant level and fill
per manufacturers instructions. Operation without lubri-
cant will damage the gear reducer. A table of sug-
gested lubricants is provided on page 24.
ENTANGLEMENT HAZARD
An exposed drive shaft must be guarded to enclose
the shaft.