Graco LSR Select, Инструкция по эксплуатации

Страница: 12 / 112

Setup
12 3A2152B
Setup
Initial Machine Setup
Perform this setup procedure to prepare the machine for
initial operation.
1.
Locate the machine.
a. Locate the machine on a level surface and bolt
to the floor. See Technical Data starting on
page 108 for space requirements and mounting
hole pattern.
b. Connect the valve stack to the screw inlet
located on the press. External brackets may be
required to support the stack. Install a valve
between the mixer and the screw. The valve
can be controlled by the LSR system. See
Appendix D - Selecting the Outlet Valve,
Mounting the Stack to the Press
on page 107.
2.
Connect the electrical cord.
Electrical Cord Requirements
NOTE: Power cord is not supplied. See the following
table.
Electrical Cord Wires by Model
230V, 3 phase: L1, L2, L3, GND
a. Connect green wire to ground (GRN).
b. Use a screw driver to tighten the terminals to
12 in-lb (1.4 N•m)
The machine is not properly grounded until this setup
procedure is performed. To prevent risk of electric
shock, do not start the machine until this setup proce-
dure is completed.
NOTICE
To prevent machine damage, do not expose system
to rain.
F
IG
. 3: Valve Stack Outlet
ti18098a
3/4” NPT
Male
Installing this equipment requires access to parts
which may cause electric shock or other serious injury
if work is not performed properly. Have a qualified
electrician connect power and ground to main power
switch terminals. All electrical wiring must be done by
a qualified electrician and comply with all local codes
and regulations.
Table 1: Power Cord Requirements
Model
Cord Requirements
AWG (mm
2
)
230V, 3 phase 8 (8.4), 3 wire + ground
F
IG
. 4: Electrical Disconnect
ti18099a
L1
L2
L3
GND