Graco LINE X LX2000, Инструкция и перечень запасных частей

Страница: 7 / 20

684-027 6
INSTALLATION
1. Secure the sprayer stand (201) to the floor in a
suitable location. Refer to the mounting hole
diagram in manual 307-551.
2. Install a bleed-type master air shutoff valve (1)
on the main air supply line to provide a remote
shutoff point for all air-powered components,
and a main line fir filter (2) to remove harmful
dirt and moisture from the compressed air
supply. See the Typical Installation on page 5
and the Accessories on the back cover.
NOTE: The air to the spray gun must be
very clean and dry to avoid contaminating
the foam.
3. Install the 1:1 ratio feed pumps (3) in 55 gallon
drums of ISO and RES.
a. Screw the bung adapter (4) and pump
tightly into the drum cover. Then
tighten the nut (5) firmly to complete
the airtight seal. See Figure 1.
b. Separate the two halves of the
ISO/RES identification label (6) along
the perforation. Clean the surface of
the air motor with solvent and apply the
appropriate label (RES or ISO). to
identify the chemical being pumped.
See Figure 1.
c. We recommend installing an air
regulator near the feed pump air inlet to
control pump speed. To install, remove
the air valve (8) and use suitable
adapters and thread sealer on male
threads to install the regulator and pin
fitting.
4. Mount the Air Dryer (9) in a suitable location
near the ISO and RES drums. See the Typical
Installation on page 5. Refer to the mounting
hole diagram in manual 307-548.
WARNING
Never pressurize a drum or container that will not
withstand 7 psi (0.49 bar) working pressure to
reduce the risk of container rupture and serious
bodily injury. Never use a damaged drum of ISO
or RES with the Air Dryer to reduce the risk of
container rupture and serious bodily injury.
a. Fill the bowl of the desiccant dryer.
Unscrew the ring (10) to remove the
dryer bowl. Refer to the Typical
Installation. Remove the filter form the
top of the bowl and fill the bowl with the
desiccant crystals provided with the kit.
Reinstall the filter and bowl.
5. Connect an air supply hose (11) from the 1/4”
npt quick disconnect coupler of each feed
pump to the air manifold (229). See the Typical
Installation.
6. Connect an air supply hose (13) between the
air inlet of the Air Dryer and the main air supply
line. See the Typical Installation.
7. Connect a grounded 1/2” minimum ID main air
supply line (14) to the air manifold (229). See
the Typical Installation.
8. Be sure all air hose connections are tight.
Figure 1
CAUTION
To avoid mixing the polyurethane foam chemicals
and permanently damaging the hoses, all critical
air and fluid connections are clearly labeled ISO or
RES. Make only ISO to ISO and RES to RES
connections.