Graco King E50, Инструкция по эксплуатации

Страница: 19 / 40

Shutdown
Shutdown Shutdown Shutdown
NOTICE NOTICE NOTICE
Never leave water or water-based fluid in pump
over night. If water-based fluid has been used,
flush with water first, then with a rust inhibitor (such
as mineral spirits). Relieve pressure, but leave rust
inhibitor in pump to protect parts from corrosion.
To shutdown:
1. Perform Prime/Flush Prime/Flush Prime/Flush,,, page page page 14 14 14 .
2. Perform Pressure Pressure
Pressure Relief
Relief
Relief Procedure
Procedure
Procedure,,, page
page
page 12
12
12
.
Maintenance Maintenance Maintenance
NOTICE NOTICE NOTICE
Do not open/remove gear cover. The gear side
is not intended to be serviced. Opening the gear
cover may alter the factory set bearing pre-load
and may reduce the product life.
Preventive Preventive
Preventive Maintenance
Maintenance
Maintenance Schedule
Schedule
Schedule
The operating conditions of your particular system
determine how often maintenance is required.
Establish a preventive maintenance schedule by
recording when and what kind of maintenance is
needed, and then determine a regular schedule for
checking your system.
Change Change Change the the the Oil Oil Oil
NOTE: NOTE: NOTE: Change the oil after a break-in period of
200,000–300,000 cycles. After the break-in period,
change the oil once a year.
1. Place a minimum 2 quart (1.9 liter) container
under the oil drain port. Remove the oil drain
plug. Allow all oil to drain from the driver.
2. Reinstall the oil drain plug. Torque to 18–23 ft-lb
(25–30 N•m).
NOTICE NOTICE
NOTICE
Do not over-torque. The drain plug can
become stripped and damaged.
3. Open the oil fill cap (P) and add Graco Part No.
16W645 silicone-free ISO 220 synthetic EP gear
oil. Check the oil level in the sight glass (K). Fill
until the oil level is near the halfway point of the
sight glass. The oil capacity is approximately
1.0–1.2 quarts (0.9–1.1 liters). Do
Do Do not not not overfill. overfill. overfill.
NOTICE NOTICE
NOTICE
Only use oil with Graco part number 16W645.
Any other oil may not lubricate properly and
can cause damage to the drive train.
4. Reinstall the oil fill cap (P).
3A8126B 19