37
1.
For ease of installation, extend UAS
belt to its maximum length.
2.
Position base in vehicle seat as
shown.
3.
Thread UAS belt through base belt
path normally used for vehicle seat
belt. Make sure that UAS is UNDER
tongue on base .
Belt must lay flat and not be twisted.
4.
Hook UAS Connectors to vehicle lower
anchors. Pull firmly on Connectors to
be sure they are attached .
5.
Tighten UAS belt by pushing down
hard on base and pulling the
adjustment belt .
6.
NEVER put two UAS connectors on
one vehicle UAS lower anchor unless
specifically allowed by the vehicle
manufacturer .
7.
Test infant restraint for secure
installation as described in infant
restraint “Final Safety Check” p.40.
8.
Check that the UAS belt stays tight and does not slip from
the tightened position. If it does not stay tight, try another
seating position or contact Customer Service.
6.4
Using UAS to install Base
Tongue
