39
1. For ease of installation, extend
LATCH
to its maximum length.
2. Position base in vehicle seat as
shown.
3. Thread
LATCH
through base belt
path normally used for vehicle
seat belt. Make sure that
LATCH
is
UNDER
tongue on base
.
Belt must lay flat and not be twisted.
4. Hook
Connectors
to vehicle lower
anchors. Pull firmly on
Connectors
to
be sure they are attached
.
5. Tighten
LATCH
by pushing down
hard on base and pulling the
adjustment belt
.
6.
NEVER
put two
LATCH
connectors on
one vehicle
LATCH
anchor unless
specifically allowed by the vehicle
manufacturer
.
7. Test infant restraint for secure
installation as described in infant
restraint
“Final Safety Check” p.42
.
8. Check that the
LATCH
stays tight and does not slip from the
tightened position. If it does not stay tight, try another
seating position or contact Customer Service.
6.4
Using LATCH to install Base
Tongue
Содержание ISPA237AA
Страница 15: ...15 13 2X On certain models Sur certains modèles En ciertos modelos SNAP ENCLENCHEZ CHASQUIDO ...
Страница 86: ...46 Notes ...
Страница 87: ...47 Notes ...
Страница 135: ...47 Notas ...