Graco IniFlex, Инструкция-перечень запасных частей

Страница: 15 / 30

Installation
3A8637B 15
Attach a Dump Plug
NOTE: The following procedure assumes a dump plug
(17) is replacing a dump manifold (9). (See the Switch
Block parts diagram on page 22 for the location of
referenced parts.)
1. Identify inlet sides 1 and 2 on the bottom manifold.
2. Loosen and remove the two screws (11 and 12) on
top of the color manifold (3), and remove the dump
manifold (9) and o-ring (6) where the dump plug (9)
will be attached. Discard the o-ring (6).
3. Lubricate a new o-ring (6) and insert it in the port on
top of the color manifold (3).
4. Align the slots in the dump plug (17) with the holes
in the color manifold (3), and secure with the two
screws (11 and 12). Torque to 80-100 in-lb (9.0-11.3
N•m).
NOTE: The longer screw (11) is inserted in the hole
towards the outlet side of the switch manifold, and the
shorter screw (12) is inserted in the hole towards the
inlet side.
Attach a Purge Plug
NOTE: The following procedure assumes a purge plug
(18) is replacing a gun flush manifold (5). (See the
Switch Block parts diagram on page 22 for the location
of referenced parts.)
1. Loosen and remove the two screws (14) on side of
the color manifold (3), and remove the gun flush
manifold (5) and o-ring (6). Discard the o-ring (6).
2. Lubricate a new o-ring (6) and insert it in the purge
port on the of the color manifold (3).
3. Align the slots in the purge plug (18) with the holes
in the color manifold (3), and secure with the two
screws (14). Torque to 80-100 in-lb (9.0-11.3 N•m).
Connect Fluid Tubes
1. Connect 5/32 in. (4 mm) OD air actuation tubes
from the valve solenoids to the air inlets (G) of each
valve. (See F
IG
. 3.)
NOTE: The color change valve uses a spring-operated
valve closure vent (20) that does not require a second
air actuation line.
2. Attach a Color Change Stack , page 14, to the
Side 1 (E) and Side 2 (F) inlets.
3. Connect the gun fluid supply line to the Quick
Socket fluid outlet port (D) of the switch block.
4. Connect the Side 1 dump hose to the Side 1 Dump
outlet port (A).
5. Connect the Side 2 dump tube to the Side 2 Dump
outlet port (B).
6. Connect the Gun Flush tube to the Gun Flush outlet
port (C)
F
IG
. 3: Connect fluid tubes to a switch block
20
G
E
F
Gun fluid
supply line
D
A
C
B
Side 2
dump tube
Gun Flush
tube
Side 1
dump tube