Flush
Flush
Flush the
the
the System
System
System (Systems
(Systems
(Systems without
without
without Color
Color
Color Change)
Change)
Change)
To flush systems that are color change enabled,
follow the steps in
Flush the System (Color Change
.
To avoid fire and explosion, always ground
equipment and waste container. To avoid static
sparking and injury from splashing, always flush at
the lowest possible pressure.
The components in the isolation system were tested
in fluid at the factory. To avoid contaminating your
fluid, flush the isolation system with a compatible
flushing fluid before you use the equipment.
Flush the system using Purge mode. In Purge mode
the system dispenses all of the fluid in the fluid
cylinder. To flush the system:
• Use Purge mode to first empty the system of paint.
• Switch to a cleaning fluid to continue to completely
fill and empty the isolation fluid pump (K) to flush
it clean.
• Press the Do Not Fill button to stop the refill
sequence:
1.
Release the gun trigger and turn off electrostatics
by disabling the electrostatic request signal.
2.
Follow the
3.
Shut off the paint supply to the unit.
4.
Use the control interface to change the mode to
Purge mode:
5.
Trigger the gun until paint stops flowing.
6.
Supply compatible cleaning fluid to the system.
7.
Deactivate the Do Not Fill button:
.
8.
The system fills until the isolation fluid pump is
completely full.
Trigger the gun until the fluid runs clear. When
the pump is empty, the fluid will stop coming
out of the gun while the pump refills. Continue
triggering the gun while the pump refills and the
gun will resume flushing once the pump is full.
9.
Activate the Do Not Fill button
so that the
isolation fluid pump will not refill after it is empty.
See
.
10. Trigger the gun until the system indicates that
the isolation fluid pump is empty.
11. Follow the
Pressure Relief Procedure, page 30
.
3A8493A
31
Содержание HydroShield WABL00
Страница 118: ...Parts Notes Notes Notes 118 3A8493A...
