Flush
Flush
Flush the
the
the System
System
System (Color
(Color
(Color Change
Change
Change Enabled
Enabled
Enabled Systems)
Systems)
Systems)
To avoid fire and explosion, always ground
equipment and waste container. To avoid static
sparking and injury from splashing, always flush at
the lowest possible pressure.
The components in the isolation system were tested
in fluid at the factory. To avoid contaminating your
fluid, flush the isolation system with a compatible
flushing fluid before you use the equipment.
Flush the system using Purge mode. In Purge mode
the system dispenses all of the fluid in the fluid
cylinder. To flush the system:
• Use Purge mode to empty the system of paint and
then flush it clean.
• To use a purge sequence, set up a
purge profile in advance. For details, see
.
• Ensure that the air line, flush material, and dump
hose are connected to the correct color change
valves.
1.
Release the gun trigger and turn off electrostatics
by disabling the electrostatic request signal.
2.
Follow the
3.
Use the control interface to change the mode to
Purge mode:
4.
Continue to flush the system by using either:
• A purge profile.
• A manual purge.
To
To
To use
use
use a
a
a purge
purge
purge profile:
profile:
profile:
1.
If using purge profile 1-5, push the flashing Play
button on the left side of the screen to run the
purge sequence:
2.
Trigger the gun until the system completes the
purge sequence.
3.
After flushing is complete, the system returns to
Standby mode.
4.
Follow the
Pressure Relief Procedure, page 30
.
To
To
To purge
purge
purge manually:
manually:
manually:
1.
If using a purge profile 0, the system must be
manually flushed. On the left side of the screen,
three icons appear that activate the dump, flush
material, and air inlet valves.
2.
If a dump hose is connected,
activate the Dump
valve button:
This pushes all of the material in the system back
out the inlet, through the dump valve, and into a
waste or reclaim container.
3.
After using the Manual Dump valve button or
if the dump line is not connected, activate the
Flush material button:
4.
Trigger the gun to push all of the material in the
system out through the gun.
5.
After the isolation fluid pump is empty, the system
lets in flush material and fills the pump. Once
the pump is full, it will pressurize and dispense
material out to the gun. Continue this process
until clean material exits the spray gun.
6.
Press the Flush material button again to
deactivate it:
If desired, the system can be left loaded with
flush material.
7.
Activate the Air button to push the remaining
flush material out to the spray gun:
Once the isolation fluid pump is empty, the
system allows air through it and out to the spray
gun.
32
3A8493A
Содержание HydroShield WABL00
Страница 118: ...Parts Notes Notes Notes 118 3A8493A...
