background image

PRODUCT

FLUID SET #2

17P485

FLUID SET #3

17P486

FLUID SET #4

17P487

FLUID SET #5

17P488

FLUID SET #6

17P489

FLUID SET #7

17P490

Dye

Ink

Non-Wiping Stain

Automotive Finish

Lacquer

Stain

Enamel

Epoxy

Urethane

Varnish

Primer

Industrial Finishes

Latex

Multi-Spec

Butyrate

Nitrate Dope

Solvent-Based Wall Paint

www.graco.com

HVLP TurboForce

™ 

II

7.0 / 9.0 / 9.5

Quick Operator’s Guide

Turn power switch to OFF position.

Fill FlexLiner™ with material to 

‘MAX FILL’ line. Clean threads and 

sealing surfaces if needed.

ROTATE air cap to 

desired spray pattern.

 

HVLP EDGE™ II PLUS.

AutoStart setting automatically turns off 

when not actively spraying. Sprayer will start 

upon re-triggering of HVLP Edge II Plus gun. 

Turn switch to ON position if AutoStart is not 

desired.

Verify trigger slide is in SPRAY 

position (A), not NEEDLE REMOVAL 

position (B).

pattern by rotating air 

cap retaining ring.

Disconnect spray gun 

from air hose.

Connect FlexLiner™ System 

to gun.

Screw cover and ring onto cup.

Tighten ring securely.

Disconnect 

gun from 

FlexLiner™ 

System.

Connect air hose to gun.

Unscrew ring 

from cup. 

Remove lid 

and ring from 

cup. Verify 

FlexLiner™ is 

in cup.

Verify trigger slide is 

in SPRAY position. 

Sprayer is now ready to use.

A

B

STANDARD

PROCONTRACTOR

PROCONTRACTOR ONLY

SETUP

CHOOSE THE RIGHT NOZZLE

OPERATION

This procedure is for water-based paints and flushing agents. For solvent-based paints and flushing agents (i.e. mineral spirits), you must first 

read the section on Fire and Explosion Hazards in the Operating Instructions. Please note this Quick Guide is at no means replacing the official 

Graco manual. Graco can at no means be liable for any consequences of not following the safety regulations as stipulated in the official manual. 

* Please check the Graco operations manual supplied with the unit for more details.

WARNING

Отзывы: