Operation
Operation
Operation
Startup
Startup
Startup
To operate the pump, follow the Startup instructions
for the Basic or Advanced motor in the Motor manual.
NOTE:
NOTE:
NOTE: The Advanced E-Flo DC motors require
installation of the 24P822 Control Module Accessory
Kit to provide the interface for users to enter
selections and view information related to setup and
operation.
Prior to normal operation, run the pump at a slow
speed until the fluid lines are primed and all air is
forced out of the system.
Shutdown
Shutdown
Shutdown
Stop the pump at the bottom of its stroke to prevent
fluid from drying on the exposed displacement rod
and damaging the throat packings, and follow the
Pressure Relief Procedure, page 12
.
Pressure
Pressure
Pressure Relief
Relief
Relief Procedure
Procedure
Procedure
Follow the Pressure Relief Procedure
whenever you see this symbol.
This equipment stays pressurized until pressure
is manually relieved. To help prevent serious
injury from pressurized fluid, such as skin injection,
splashing fluid and moving parts, follow the
Pressure Relief Procedure when you stop spraying
and before cleaning, checking, or servicing the
equipment.
1.
Disengage the start/stop control (C). See Fig. 1.
2.
Shut off and lock out the fused safety switch (B).
3.
Open the fluid drain valve (H), having a waste
container ready to catch drainage. Leave open
until you are ready to operate again.
Flushing
Flushing
Flushing
To avoid fire and explosion, always ground
equipment and waste container. To avoid static
sparking and injury from splashing, always flush at
the lowest possible pressure.
• Flush before changing fluids, before fluid can dry
in the equipment, at the end of the day, before
storing, and before repairing equipment.
• Flush at the lowest pressure possible. Check
connectors for leaks and tighten as necessary.
• Flush with a fluid that is compatible with the fluid
being dispensed and the equipment wetted parts.
12
3A6358A