Graco Geo Blaster GB1200, Операция и комплектующие

Страница: 4 / 54

Warnings
4 3A4167C
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-
tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When
these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific
hazard symbols and warnings not covered in this section may appear throughout the body of this manual where
applicable.
WARNING WARNING WARNING
DUST AND DEBRIS HAZARD
Use of this equipment can result in the release of potentially harmful dust or toxic substances from
the abrasive being used, the coatings being removed, and the base object being blasted.
• For use only by sophisticated users familiar with applicable governmental safety and industrial
hygiene regulators.
• Use equipment only in a well-ventilated area.
• Wear a properly fit-tested and government approved respirator suitable for the dust conditions.
• Follow local ordinances and/or regulations for disposal of toxic substances and debris.
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated system
component. See
Technical Data in all equipment manuals.
• Do not use this equipment without hose restraints and coupler pins installed on all air and blast
hose couplings.
• Do not blast unstable objects. The high amount of fluid flow from the nozzle can potentially move
heavy objects.
• Do not exceed load rating of lift eyes.
• Do not operate equipment on or stand on an unstable support. Keep effective footing and balance
at all times.
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in
all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete information
about your material, request Safety Data Sheets (SDSs) from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the Pressure Relief Procedure when equipment is not in use.
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine man-
ufacturer’s replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals and cre-
ate safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.