Graco G3000, Инструкция по эксплуатации

Страница: 20 / 42

Display Module
Display Display Display Module Module Module
Display Display Display Information Information Information
The Display Module provides the interface for users
to enter selections and view information related to
setup and operation.
The screen backlight is factory set to remain on,
even without screen activity. See Setup
Setup Setup Screen Screen Screen 3 3 3
to set the backlight timer to your preference. Press
any key to restore.
Keys are used to input numerical data, enter setup
screens, navigate within a screen, scroll through
screens, and select setup values.
NOTICE NOTICE
NOTICE
To prevent damage to the softkey buttons, do not
press the buttons with sharp objects such as pens,
plastic cards, or fingernails.
Operation Operation
Operation Modes
Modes
Modes
The Informer has two operation modes: Run Mode
and Setup Mode. For detailed information see
Run Screens, page 23 , and Setup Screens, page 25 .
Press to toggle between these two modes.
Screen Screen
Screen Navigation
Navigation
Navigation and
and
and Editing
Editing
Editing
Refer to this section if you have questions about
screen navigation or about how to enter information
and make selections.
All All All Screens Screens Screens
1. Use to move between screens.
2. Press to enter a screen. The first data field
on the screen will highlight.
3. Use to highlight the data you wish to
change.
4. Press to edit.
Drop Drop Drop Down Down Down Field Field Field
1. Use to highlight the correct choice from
the dropdown menu.
2. Press to select.
3. Press to cancel.
Number Number Number Field Field Field
1. The first digit will be highlighted. Use
to change the number.
2. Press to move to the next digit.
3. When all digits are correct, press again to
accept.
4. Press to cancel.
Check Check Check Box Box Box Field Field Field
A check box field is used to enable or disable features
in the software.
1. Press to toggle between and an empty
box.
2. The feature is enabled if a is in the box.
Reset Reset
Reset Field
Field
Field
The reset field is used for totalizers. Press to
reset the field to zero.
When all data is correct, press to exit the screen.
Then use to move to a new screen, or
to move between Setup Mode and Run Mode.
20 3A2040H