Graco BULLDOG 210-302, Инструкция-перечень запасных частей

Страница: 13 / 24

13 307-050
Service
Piston Repair
(See Fig. 9)
12. Remove the screws (44) and lockwashers (39) and
pull the cylinder (81) straight up off the piston. Re-
move the dampener pad (61) and washer (60).
13. Remove the trip rod bearing (1), using a 1 in.socket
wrench. Remove the gasket (51), washer (54) and
packing (55) from the bearing.
14. Pull the piston (89), piston rod (90) and trip rod (33)
up out of the base (2). Remove the o–ring (62).
15. Place a wrench on the turned down part of the piston
rod (90) and screw out the stud (73).
16. Place a wrench on the top of the trip rod (33) and turn
the rod clockwise until the top socket (72) is free.
Then count the number of turns it takes to screw out
the bottom socket (71). Write the number down: it is
important when reassembling the motor.
NOTE: If the trip rod is broken, use a 9/16 in. hex key
wrench to remove the bottom socket (71). A
damaged trip rod cannot be repaired; use a new
one.
17. Remove the trip rod (33) from the piston rod (90).
See Fig 7.
01820
62
90
33
89
Fig 7
Reassembly
(See Fig. 9)
1. Clean all parts thoroughly and inspect for wear or
damage. Replace parts as necessary.
2. Screw the bottom socket (71) into the piston rod (90)
the number of turns you counted in Step 16, above.
The end of the socket should extend 1/8 in.(3 mm)
from the piston (89). Slide the trip rod into the piston.
Install the top socket (72), turning it clockwise until
the socket is flush with the top of the piston; the bot-
tom socket should be 1 in. (25 mm) into the piston
rod. See Fig 8.
Fig 8
50
73
62
33
89
1
3
72
1
2
3
Flush with piston (89)
when assembled corectly
Apply thread locking
compound
1” to threaded
part when
assembled
correctly
3. Place a copper gasket (50) on the piston stud (73).
Apply thread sealant to the stud threads, and screw
the stud firmly into the piston assembly.
4. Check the adjusting mechanism by turning the trip
rod (33) clockwise until it stops. The top socket
should extend about 1/16 in. (2 mm) above the pis-
ton. Now turn the rod counterclockwise until the
socket is again flush with the piston.
5. Grease the cavity in the base (2) and install a washer
(57*) and a v–packing (56*) so the lips of the v–pack-
ing face up in the base.