Installation
3A5405B
3
5. Insert winch assembly into one of the adapter brack-
ets (1) and secure with pin (9).
6. Slide terminal boots (supplied) onto both ends of the
blue and yellow cables (25). Connect each cable to
the corresponding color-coded terminal on the
winch. Cover terminal with terminal boot.
7. Install split sleeving (26) over cables (25) and cut to
needed length.
8. Connect blue and yellow cables (25) from the winch
terminals to the blue and yellow color-coded termi-
nals on the winch switch terminal. Cover terminal
with terminal boot. See
Wiring Diagram,
page
NOTE:
If the winch runs in the opposite direction as indi-
cated on the control, swap the positions of the yellow
ans blue wire connections on the winch.
9. Plug in winch controller (19) to the connector at the
junction box. Properly protect and secure all wires to
keep from damaging them during every day use.
25
