9.
Remove the check balls (22), d-rings (21), and
wearable seats (19) from the outlet side of each
fluid cover (6).
10. To remove the nuts (28) and bolts (24), use two
13 mm wrenches to hold on one side and turn
the other. The nuts (28) will come off of one side
only. Then remove the bolts (24).
NOTE:
NOTE:
NOTE: The nuts are permanently affixed to one
end of the bolts.
11. Remove the fluid cover retainers (9) and the fluid
covers (6) from the body (1).
Replace
Replace
Replace the
the
the Anchor
Anchor
Anchor Strap
Strap
Strap
1.
While the fluid cover retainers (9) are removed,
inspect each anchor strap (31) for damage.
2.
If it is necessary to replace an anchor strap, use
a 3/16 in. hex wrench to remove the four screws
(33) securing the anchor strap (31) to the fluid
cover retainer (9).
3.
Align the four holes in the new anchor strap (31)
with the corresponding holes in the fluid cover
retainer (9) and the four screws (33).
4.
Use a 3/16 in. hex wrench to tighten the screws
(33).
Disassemble
Disassemble
Disassemble the
the
the Center
Center
Center Section
Section
Section
1.
One diaphragm (25) and strike plate (4) should
screw off by hand. Slide the second diaphragm
and strike plate out with the shaft (5).
2.
Inspect the o-ring seals (32) and glide seals (39).
Replace as needed.
3.
Carefully remove the cap plugs (37) from both
muffler locations.
4.
Use a 4 mm Allen wrench to remove the screws
(16) and muffler caps (14).
334796G
19
Tel: 866-777-6060
Fax: 866-777-6383
Springer Pumps, LLC
Website: www.springerpumps.com
Int'l: +001 267 404 2910
