Installation – Roller Support Arm
Hose reels are shipped from the factory with the roller
support arm (10) at a 45
_
angle. If your application
requires the support arm to be in a vertical position for
a ceiling mount, follow the procedure below.
Changing the Position of the
Roller Support Arm
CAUTION
Change the arm before you mount the hose reel.
If the hose reel is already mounted, remove the
reel from its mounting, and move it to a
workbench. If you are removing the hose reel from
an overhead mounting, use a lift truck.
The procedure below maintains a minimum of two
screws holding the pedestal (1) and the flange (13)
together.
1.
Lay the reel on a flat surface so the pedestal (1) is
on the bottom.
2.
Extend the hose and hose stop 6 to 12 in.
(15 to 30 cm) beyond the rollers, and latch the
reel.
3.
Remove the capscrew at position E, replace it in
position H, and tighten the capscrew.
4.
Remove capscrews at positions C and G.
5.
Reposition the roller support arm (10) to the
vertical position.
6.
Insert capscrews in position B and F, and tighten
them. See Fig. 2.
7.
Remove the screw at position A, reinsert it at
position D, and tighten it.
8.
Unlatch the hose, and allow it to retract.
9.
Remount the reel, or continue with the installation
procedure on page 8.
Fig. 2
1
13
10
6-12"
(15-30 cm)
03911
Содержание 237020
Страница 26: ...Notes...
Страница 27: ...Notes...