Graco 237-418, Инструкция-перечень запасных частей

Страница: 5 / 16

Setup
I. Prepare the operator.
All persons who operate the system should be trained
in the safe, efficient operation of all system compo-
nents as well as the proper handling of the chemical
coating. At a minimum, all operators should
thoroughly read the safety, installation and operation
sections of this manual and the component manuals.
II. Prepare the site.
1. Use a minimum recommended 5 HP (3.7 kW) air
compressor for efficient operation.
2. Clear obstacles and debris that could hinder the
operator’s movement.
3. Bring an air line from your compressed air supply
to the pump location. Be sure the air is dry and
filtered. Install a bleed–type master air valve (A)
upstream from the pump. Another master air valve
(14) is supplied with the package. When the
bleed–type master air valve is closed and the
pump air regulator (8a) is opened, the valve
relieves all air pressure to the system.
4. Have a grounded, metal waste–pail available to
use when draining the fluid filter.
5. Ventilate the spray booth.
WARNING
To prevent hazardous concentrations of toxic and/
or flammable vapors, spray only in a properly venti-
lated spray booth. Never operate the spray gun
unless ventilation fans are operating.
Check and follow all of the national, state and local
codes regarding air exhaust velocity requirements.
Fig. 1
A
B
C 30
1
8b
8a
04072
KEY
Components you must supply:
A Bleed-type master air valve
Required for pump; order
part no. 107–142, 1/4” npt(f)
B Air filter. Order part no.
106–149, 1/2 npt(f)
C Air supply line
D Grounded 5 gallon metal pail
E Air line moisture trap
Components supplied with package:
1 23:1 Monark pump
3 Air-assisted airless spray gun
4 Spray tip
6 Gun fluid hose
7 Gun air hose
8a Pump air regulator
8b Gun air regulator
14 Bleed–type air valve
30 Pump ground wire
E
6
7
3,4
14
C
D