Graco 235345, Инструкция-перечень запасных частей

Страница: 7 / 30

Installation
307158ZAP 7
Refer to the complete pump manual for detailed
installation information or contact your Graco
distributor.
NOTE : A 1 in. npt seal (57) is supplied in a plastic bag
with the motor. Thread the seal onto the threads of your
hydraulic return line fitting (A). Thread the fitting into the
upper housing (40) and torque as needed. Then tighten
the seal (57) against the motor to provide a secure seal.
See Fig. 1.
F
IG
. 1 ___________________________________________
Grounding
Proper grounding is an essential part of maintaining a
safe system.
Check your local electrical code for detailed grounding
instructions for your area and type of equipment. Be
sure to ground all of this equipment:
• Pump : use a ground wire and clamp as shown to
the right.
• Hydraulic hoses and fluid outlet hoses : use only
electrically conductive hoses.
• Hydraulic power supply and air compressor :
follow manufacturer’s recommendations.
• Spray gun : obtain grounding through connection
to a properly grounded fluid hose and pump.
• Fluid supply container : according to local code.
• Object being sprayed : according to local code.
• Any pails used when flushing : Use only metal,
grounded pails when flushing. Make firm
metal-to-metal contact between the metal part of
the spray gun and the pail. Use the lowest possible
pressure.
• To maintain grounding continuity when flushing or
relieving pressure, always hold a metal part of the
gun firmly to the side of a grounded metal pail, and
then trigger the spray gun.
Models 217338, 235345, and 262818
Remove the ground screw (B) and insert through the
eye of the ring terminal at the end of the ground wire
(A). Fasten the ground screw onto the pump and tighten
securely. See Fig. 2. Connect the other end of the wire
to a true earth ground. To order a ground wire and
clamp, order part number 222011.
Model 24W139
Remove the ground screw (B) and insert through the
eye of the ring terminal at the end of the ground wire
(A). Fasten the ground screw onto the pump and tighten
securely. See Fig. 2. Connect the other end of the wire
to a true earth ground. To order a ground wire and
clamp, order part number 26B091.
Model 217022
The ground wire and clamp are supplied with your GH
Sprayer. Connect the clamp to a true earth ground as
recommended by your local code.
F
IG
. 2 ___________________________________________
The equipment must be grounded to reduce the risk
of static sparking. Static sparking can cause fumes
to ignite or explode. Grounding provides an escape
wire for the electric current.
57
40
A
04467
A
B