Fig. 37
61
68
60
Torque to 125 in–lb (14 N.m)
B
C
A
0047
Fig. 38
66
61
156
157
64
0048
35
308-082
Clamp
NOTE: A standard steering wheel puller is re-
quired to remove the clamp. Two 1/4–28 x 3 or 4
in. long screws are also needed.
NOTE: Refer to Fig. 37.
1.
Loosen the two screws (60) on the clamp (68),
working through the slot at the bottom of the
clutch housing (61).
2.
Install two screws (B) of the tool (A) in two of
the threaded holes in the clamp. Tighten the
screws (C) until the clamp comes off.
3.
Skip ahead to Reassembly, page 36, Step 3,
or continue below.
Clutch Housing
NOTE: Refer to Fig. 38.
1.
Remove the four capscrews (156) and lock-
washers (157) which hold the clutch housing
(61) to the engine (64).
2.
Remove the engine key (66).
3.
Pull off the clutch housing (61).
4.
Skip ahead to Reassembly, page 36,
Step 1.
Содержание 231-132
Страница 47: ...47 308 082 Notes ...