Installation
Gun
1.
This gun includes an inlet filter suitable for latex
paint. Contact your Graco distributor to order a
stain/enamel filter. To install, screw out the filter
cap. Push the filter into the fluid tube. Reinstall the
gasket with the lips facing into the gun. Reinstall
the cap and tighten with a wrench. See Fig 1.
2.
Connect a grounded fluid hose from your pump or
sprayer to the gun’s 1/4–18 npt(m) inlet.
3.
Remove the RAC IV DripLess tip guard from the
gun (Model 220–730 only).
4.
Flush and then prime the pump or sprayer as
instructed in the separate pump or sprayer manu-
al. Relieve fluid pressure and engage the gun
safety lever.
5.
If you have a RAC IV DripLess T
ip Guard and
SwitchTip, refer to the installation instructions
below.
For any other type of tip guard, refer to the instruc-
tions supplied with it for installation and operation.
Fig 1
GASKET
FILTER CAP
FILTER
1/4–18 npt(m)
FLUID INLET
