11. Align the inlet manifold (10) on the assembly.
Orient the manifold so the inlet port is facing the
correct direction for your application (either the
same as, or the opposite from, the exhaust port).
12. Align the inlet manifold retainers (12). Place a
belleville washer (27), then a washer (26) on
each bolt. The rounded side of the belleville
washer must face toward the head of the
fastener. Install the bolts (29), just hand-tight for
now, then flip the pump over.
13. Assemble the top checks. Insert the seat (21†)
with the chamfered side up, the ball (22†), and
the outlet ball retainer (19†).
14. Carefully remove the manifold bolts (29) from
the top of the fluid covers (6), keeping nuts (18)
aligned.
15. Align the outlet manifold (8) with the dowels on
the top of the body.
16. Align the outlet manifold retainers (11). Place
a belleville washer (27), then a washer (26) on
each bolt. Install the bolts (29) hand-tight.
17. Follow
18. Replace all bolt covers (37†).
Figure 1
334792B
21
Springer Pumps, LLC
Telford, PA 18969
Tel: 866-777-6060 / Int'l: 215-949-2900
Fax: 866-777-6383 / Int'l: 215-721-1296
shop.springerpumps.com
