Graco 204490, Инструкция по эксплуатации

Страница: 9 / 28

Typical Installation
306556T 9
5. Secure the pump to the pump mounting brackets
(86) from the underside with screws (68).
6. Adjust the inductor plate on the pump so the pump
intake slots are located just below the bottom of the
inductor plate cone (see F
IG
. 5).
7. Tighten the lock nut (11, 24 or 114) securely.
Model 204490
Refer to F
IG
. 6 for Steps 1-3, below.
1. Lubricate the o-ring (20) in the inductor plate (18)
with light, waterproof grease.
2. Guide the pump intake valve as far as possible into
the inductor plate, then tighten the set screws (19).
4. Loosen the pump support brackets (83) and raise
the support (64) until it meets the pump base.
5. Secure the pump to the pump support mounting
bracket (86) from the underside with screws (68).
Model 25P544
Refer to F
IG
. 5 and F
IG
. 7 for Steps 1-6 below.
1. Position the pump mounting brackets (86), then
tighten the set screws to secure in place.
2. Mount the bung adapter plate (117) to the pump
mounting brackets (86) using cap hex screws (118).
3. Remove the inductor plate nut (114), ferrule (115)
and the o-ring (113) (F
IG
. 5).
4. Lower the pump tube through the bung adapter
plate (117).
5. Using this order, slide the inductor plate nut (114),
ferrule (115), and the o-ring (113) on the pump riser
tube (F
IG
. 5).
6. Adjust the inductor plate on the pump so that the
pump intake slots are located just below the bottom
of the inductor plate cone (see F
IG
. 5).
7. Tighten the lock nut (114) securely.
8. Loosed the pump support clamps and raise the
support (64) until the bung adapter plate (117)
meets the bung adapter on the pump tube.
9. Turn the bung adapter into the bung adapter plate
until tight.
F
IG
. 6:
18
20
19
F
IG
. 7:
117
86
bung
adapter