10
Wire Attachment
NOTE:
• When wiring the SureStitch make sure that your sewing machine is turned off, and
unplugged from power, (this will ensure that when your sewing machine is turned on, it will
accept the SureStitch as it’s speed control).
• Leave a little slack in the wires near the wire connectors, to prevent the connector from
being pulled out, or damaged.
• Secure the wires to the carriage using the included velcro straps, tie mounts, and zip ties.
Keep the wires taut between the velcro straps, and keep the wires organized.
• When there is more wire than you need, coil up the extra wire, and secure it to the carriage
so that it is out of the way.
Step 6-1:
Attach the Display Wire (See Fig. 6-1, and Fig 6-2) to the Display Console, and to
the Control Box. Be sure to line up the pins in the connectors to avoid bending them. Secure
the wire to the carriage to keep the wire organized.
6-2:
Attach the wires from each of the encoders to the Control Box.
It doesn’t matter which wire goes into which of the Telephone Type
connectors. Secure the encoder wires to the carriage using Tie
Mounts and Zip Ties to keep the wires organized.
NOTE:
When securing the wires for the bottom plate encoder, be sure to leave enough slack to
allow the top plate to travel its entire available distance. This will prevent damage to the encoder
wire. Also, use a tie mount to secure the encoder wire to the bottom plate to prevent the wire
from rubbing on the quilting frame table when the carriage is being moved.
Fig. 6-1
Display Wire Connector
Operating SureStitch
