Parts & Tools Needed:
1. Make sure that the Display Cable goes
up through the gap between the Display
Clip and the OLED Display and twist it 180
degrees so that the Display Cable Connector
is positioned as shown above
2. Install the display by pressing the display clip
into the slot until it clicks into place, then
plug the Display Cable Connector into the
Display Cable Port.
M6 x 10mm
SBHCS (2)
Thread Mast
Assembly
OLED Display
and Cable
4mm T-Handle
Allen Wrench
3. Attach the Thread Mast Assembly by
screwing it to the side of the machine using
two M6 x 10mm SBHCS
4
|
Setup & Assembly
Display & Thread Mast Setup
OLED
Display
Display
Cable
Connector
M6 x 10mm
SBHCS
Thread
Mast
Assembly
Twist the
Cable 180
Degrees
Display
Cable Port
Display
Clip
OLED
Display
Display
Cable
Display
Cable
Connector
Display
Clip