P.6
NOTE:
IF disruption should occur (signal breaks up), press the
“SCAN”
auto-tuning
button on the speaker to maximize best reception.
If you hear interference from other components, switch between the
channels
on
the transmitter and press the
“SCAN” auto-tuning
button for best reception.
NOTE:
batteries should be removed from the transmitter & speaker in cases of
extended storage periods. Move the speakers indoors when weather conditions
are extreme.
6.
Outdoor, Water Use & Weather Conditions
Schooners II speaker is designed to be used in conservative outdoor
conditions
The speaker should not be operated in extreme temperature
The transmitter and adapters must NOT be used in any type of water body
or in a moist or wet environment.
WARNING:
The power adaptor included with your unit is intended for indoor
environments and use. Do NOT use the power adapter in moist or wet
environments. Where there is a chance of rain, you may operate the speaker with
battery power.
TROUBLE SHOOTING
NO SOUND
- Check that the batteries are fully charges on the speaker
- Check there is not too much water retention inside the speaker grill. Turn
over the speaker and let the water drain out from the speaker grill.
- Ensure the AC/DC adaptor is fully inserted into the AC outlet and the power
connection input on the transmitter.
- Ensure the speaker is switch ON.
-
Speaker’s battery capacity is low,
connect the AC/DC adaptor to the speaker.
- Ensure the TV or audio component is ON.
- The volume of speaker is too low, adjust the volume to an appropriate level.
DISTORTED SOUND
- Press the
“AUTO-TUNE” button on the speakers to find the transmitter frequency
- Check there is not Too much water retention inside the speaker grill. Turn
over the speaker and let the water drain out from the speaker grill.
- Change the position of the channel selector on the transmitter. Press
“AUTO
TUNE” button on the speaker.
- Ensure the volume level of speaker is adjusted properly.
- The speaker is too far away from the transmitter, move it closer.
- Audio input level of the audio signal is too low. Turn up the audio source volume
- The Transmitters audio input level is too high, lower the audio source volume level
- Ideally the audio source is ON and volume level is set to at 50-75% of maximum.
