GPX MOTO ZS172FMM-5, Руководство по эксплуатации и обслуживанию

Страница: 3 / 8

1. When the engine is started in a non-neutral gear, the clutch should be fully
disengaged. When starting the engine from cold, close the choke valve and
operate the throttle valve gently to start. After running for 1~3min,
accelerate again.
2. When starting with electricity, the starting time should not exceed 5 seconds
each time, and the interval between restarting should be 10 seconds. If it fails
to start 5 times in a row, check whether there is any fault. After starting the
operation, it is strictly forbidden to press the start button again.
Note: If the battery power is not enough, it can be used after driving for a few
kilometers.
3
. After the cold engine is started, the
1
to
3
engine speed should be
gradually increased after
4.of the new machine:
very important, if the running-in is not good, the
failure will increase
. (1)
During the running-in
0
~
500
kilometers, the engine should not
be subjected to excessive load, and the throttle should not be
fully opened to avoid using the same gear for a long time. ,
the speed of the vehicle should not exceed
30Km/h
;
(2)
Within
500
~
1000
kilometers, the engine should not be
subjected to excessive load, the throttle should not be fully
opened, and each gear can only be
80%
driven at a speedAvoid
using the same gear for a long time, and the vehicle speed
should not exceed
50Km/h
;
(3)
The new engine
500Km
should be maintainedClearance, clutch
release stroke, etc.
5. Daily maintenance:
(
1) After the running-in period, generally replace the lubricating oil after
driving for 2000 kilometers or after each race. If the oil quality changes, it can
be replaced in advance;
(2)Turn the oil dipstick to check the oil level before driving every day, if the
oil level is lower than half of the gaugeadjust
the valve clearance. Generally, the valve clearance has been adjusted when
the engine leaves the factory. When abnormal noise occurs in the cylinder
head, the valve clearance can be adjusted to the specified value: 0.04mm ~
0.06mm;
(4) The carburetor should be cleaned regularly, and necessary inspection and
adjustment should be carried out;
(5) The air filter should be cleaned regularly Inspection and cleaning: first
remove the filter element, if it is a sponge filter element, wash it with
detergent, dry it after washing, and then apply a little oil on the filter element
and install it; if it is a disposable paper filter element, replace it with a new
filter element directly. Yes;