The first line is the latitude of the tracker.
The second line is the longitude of the tracker.
The third line is the speed of the tracker (the speed maybe is not zero if the
object is not moving because of the GPS precision)
The fourth line is the direction of the tracker( It is the direction of the tracker
moving to, from the north it is 0, and the east is 90, and the south is 180, and
the west is 270, full circle is 360, it is clockwise, the direction maybe is not right
if the object is not moving because of the GPS precision).
The fifth line is the GMT time and date, (this time is the world standard
Greenwich time, and this time is the 0 degree longitude line time, your local
time need add or minus a fixed number of hours, for example China Beijing
time is GMT add 8 hours, it means it is 8 hours earlier than GMT ).
The sixth line is the tracker battery capacity, if the battery is lower than 10%,
tracker will send battery low information to preset phone number.
4. If the tracker can not receive the GPS signal, it can not locate current location,
then it will send the last locating information to caller, and add a warning
information “GPS signal weak, Last located:” , the following information is the
last locating information.
5. User visit our website
www.followmegps.com
to input the latitude & longitude
can locate tracker on the flat map or earth map, also user can use free Google
Earth to locate the tracker.
¾
Sending SMS to Trigger Locating and Sending Back SMS Location
Send SMS “SMSLOCATE*123456” to the tracker, “SMSLOCATE” is a command,
“123456” is password; the tracker will locate immediately and send back the
location information (latitude longitude speed battery time etc) of current location
to the caller. The SMS example is same with above, if the command or password
is not right, the operation is fault, the tracker will send back information “Bad
Command ” or “Wrong Password.
¾
Set Calling Trigger Mode to Google Map Link Mode: Suit for smart phone user.
1. Send SMS “LINKMODE*123456” to the tracker, “LINKMODE” is a command,
“123456” is password; if the operation is success, the tracker will send back
