For technical product queries, please reach out to [email protected]
Thank you for purchasing a GPS-FC24-AC air ionization system from Global Plasma Solutions.
Hardware Provided by GPS
Before you start, confirm the contents of your shipment. Each GPS-FC24-AC will consist of the
following
1. GPS-FC24-AC with in line power switch.
2. Rare earth magnets (2).
3. Machine screws and nuts (2 each) for mounting magnets.
Hardware by Others
1. Electrical wiring, junction box, or receptacle to provide power to the GPS-FC24-AC.
2. Self-tapping screws (optional) if not using magnet mount.
3. Zip ties.
Installation Location
CAUTION: MAKE SURE POWER IS DISCONNECTED TO THE HVAC EQUIPMENT BEFORE INSTALLATION
GPS recommends mounting the GPS-FC24-AC after the filtration system and after the coil(s) section(s) in the HVAC
system. In ductless mini-split ceiling cassette applications, it is suggested to mount the unit to the fan inlet. The
emitter brushes should be no closer than two inches from any wiring or metal objects.
NOTE: Use Temperature - Maximum Ambient temperature in which unit shall be used: 140 degree F/ 60°C
Mechanical Installation
1. Ensure power to the HVAC equipment and the circuit the GPS-FC24-AC will be connected to has been turned
off.
2. Find an appropriate location. Verify the carbon fiber emitters have a 2” clearance from wires or other metal
objects.
3. Mount the magnets to the GPS-FC24-AC using included hardware. See FIGURE 1.
4. When mounting in a ceiling cassette use zip ties to secure GPS-FC24-AC to fan inlet screen or grid. NOTE: if
mounting in a ceiling cassette that has a self cleaning filter, the unit must be mounted behind the screen and
self cleaning system, but before the fan inlet.
5. Install the GPS-FC24-AC so that airflow is passing by both emitters at the same time (like a football through
goalposts). Make sure the unit is positioned so it obstructs as little airflow as possible.
Figure 1
!
