Gpstracker.net.in
Freedom is lost now…!
management phone, at the same time, the LED display advertising SOS suggest (should install
external LED screen already)
(7)
Illegally starting alarm: when vehicle is armed, and did not disarm, power on it directly,
monitoring center will receive illegally starting alarm info.
(8)
Illegally moving alarm: when vehicle is armed, and did not disarm, when the car was moved,
monitoring center will receive moving alarm info.
(9)
GPS antenna cutting alarm: GPS antenna open/short circuit, the car terminal will automatically
report GPS antenna cutting alarm info to the center.
(10)
Vibration alarm: when vehicle is armed, if there is vibration it will send alarm.
(11)
Cut off electricity alarm: when vehicles external power supply is cut off , it will send alarm.
(12)
Trailer alarm: If the vehicle was moved in the status of vehicle engine(ACC) is not started, it
will send an alarm info.
(13)
Oil volume alarm: When the oil is lower the pre-set value, it will take place alarming.
Four: Mileage statistics
The system can figure out the driving mileage on the very day automatically,also you can check and
calculate the mileage in any period of time.
Five: Customize of high/low TTL signal detection
The terminal will reserve one TTL electrical level(high or low level according to the user-defined)
to input signal detection line.The user can customize the signal detection function on the basis of
their needs.(For example,it can connect with the original siren in the vehicle to realize the linkage
alarm.)
Six: The function of remote maintenance and automatic maintenance
(1)
Can check the information of the terminal remotely, such as the version No. of the terminal
software, GPRS parameter, the ID No. of the main unit, the time serial number etc. Can reboot and
repair the terminal remotely.
(2)
The terminal will reboot the GPRS or GPS communication module automatically if it works
abnormally.
Chapter Two: State instructions
