Accessory: GPSI-3900 Driver ID
Link: https://help.gpsinsight.com/installation-guide/gpsi-3900-driver-id/ Last Updated: March 24th, 2017
Copyright ©2021 GPS Insight
Page 1 of 9
The installation kit contains one iButton Reader, one plastic washer, one metal locking washer, four butt
connectors, two key fobs, and one buzzer, or one light. Additional tools and supplies you need include one drill,
one 10 mm. drill bit, one 13 mm. drill bit (light), wire strippers, a crimping tool, electrical tape, and zip-ties.
Installation Overview
The following steps provide an overview of the installation process:
Determine the mounting location
1.
Prep the mounting location
2.
Assemble iButton Reader and run wires to device
3.
Connect iButton Reader to device
4.
Install Driver Notification System
5.
Verify installation and reassemble dash
6.
Installation Steps
1. Determine the mounting location.
Before you begin, it is important that you sit in the driver’s seat to determine a suitable mounting
location. The iButton Reader and light (if applicable) should be visible and easy to reach from the driver’s
seat.
2. Prep the mounting location.
Carefully pull back the dash panel where the Driver ID kit is being installed.
1.
Next, confirm the area directly behind the mounting location is clear of any interference so there
2.
are no issues reassembling the dash with the iReader installed.
