Skip AUTO.BAS program
User can use TSPL2 command to save a code auto-
file (AUTO.BAS) into flash. When turn on printer, printer
run the program automatically.
running
will
If you want to skip AUO.BAS program on power-up,
below steps:
then follow
Press and hold PAUSE and FEED button, then turn on the
Power indicator (blue) is off and Error
and FEED button, printer
Power
printer. When
indicator(red)is on, release PAUSE
will skip running AUTO.BAS program, and then
indicator will be on.
Printer Initialization
A.Turn off the printer.
B.Press and hold
PAUSE
and
FEED
button, then turn on the
printer. When Power indicator(blue)is on and Error indica
-tor (red) is off, release PAUSE and FEED button, all data
printer DRAM will be cleared and printer setting will be
restored to factory default setting. Then power indicator
will be on and printer goes to ready status.
in
Note:
Factory
default
settings
do
not
include ribbon setting
.
Ribbon Detection
When printer power turn on, printer will automatically detect
ribbon status, to check if ribbon installed, or ribbon end, or
work normally. After ribbon detecting, printer will be set to
thermal transfer printing mode or direct thermal printing
mode. If no ribbon, system will go to direct thermal printing
mode and close ribbon rolling motor function.
* The printer default values are as below.
Parameter
Default
setting
Speed
Density
Gap
Direction
4inch/sec (101.6mm/sec), 300dpi
7
0mm
0
0
ON
ON
OFF
OFF
ON
ON
CLEAR
NOT CLEAR
Top left corner from printing direction
Printing content are placed on page from top
to bottom
Reference
SHIFT
OFFSET
SET TEAR
SET HEAD(Cover open detect)
Set PRINTKEY
SET REPRINT
SET KEY1(FEED)
SET KEY2(PAUSE)
CLEAR RAM
CLEAR FLASH
14
