INTRODUCTION
Section 1 - Page 6
STEP 5 – TOOLS
The kit includes:
0.9 Allen key (1x)
0.9mm (if you use your own please ensure it’s good quality and not worn, as
this can easily cause the M2 grub screws to be damaged)
2mm drill bit (1x)
Used to open up any holes in the printed parts to ensure precision clearances,
e.g. the suspension hinge pin holes. Only use drill where indicated!
1.5mm drill bit (1x)
Used for the scale spark plug lead wire holes and windscreen mounting holes.
Sand paper (1x)
180 grit – coarse; to clean up the printed parts edges
Sand paper (1x)
600 grit – fine; to polish any corner/edges to look pretty!
Others required:
Allen drivers
1.3mm, 1.5mm, 2.0mm & 2.5mm
Socket Driver
5.5mm (for the M3 wheel nuts)
Scalpel
Trimming excess material off plastic parts. Optionally cutting out stickers.
Scissors
Cutting out stickers.
Silicon Grease
Any thick silicone-based grease – used for the friction shock lubrication.
Normal ~thin shock oil NOT recommended as shocks are not sealed.
Double-sided tape
Secure your ESC and Receiver….and Transponder maybe?
Optional:
Small Pliers
Can be useful, e.g.: inserting and removing the suspension hinge pins.
Tweezers
Pick up/hold smaller screws/items!
Callipers/ruler
For measuring screws to ensure correct usage